I just posted a few pictures of three things I have recently finished. Go have a look at the Metals 2010 page.
Project 1) The necklace was made using scrap silver that I cast into an ingot, then rolled out and roller printed. I then had to saw, file and drill each square so I could mount them on the chain I had made.
Project 2) This is a repousse sample I made as a test to see how the designs would look. I plan to use these in some of the trinket trays I make
Project 3) Glider - this started as triangle of flat copper. I had some problems because I did not have the right size stake when I started. A new one was acquired and then it came into shape really easy.
Project 1) The necklace was made using scrap silver that I cast into an ingot, then rolled out and roller printed. I then had to saw, file and drill each square so I could mount them on the chain I had made.
Project 2) This is a repousse sample I made as a test to see how the designs would look. I plan to use these in some of the trinket trays I make
Project 3) Glider - this started as triangle of flat copper. I had some problems because I did not have the right size stake when I started. A new one was acquired and then it came into shape really easy.
RSS Feed